DWG |
Addendum |
48.01 |
Add note for drilling .420" flat
bottomed holes: Take rake off drill bit. Center drill and rough with stub
length drill. |
48.01 |
Item 3) Dowel Pin -3/16" DIA. x
1" LG Qty 10 |
48.02 |
Rear barrel plate, The .125"
deep x 25 degree cutouts and the pins are *only* needed for the drum
magazine, not necessary if you are only building the stick magazine. |
48.04 |
Rifle barrel assembly. Add note:
Leave liner ½" long on each end. Tin the liner on the lathe at low
speed, sand 1 ½" each end. |
48.05 |
"Face ends of spacer tube square
and to length as shown on drawing". ADD: 9 1/4" |
48.09 |
Ignore the comment about "two
different length side brackets". They are the same length. |
48.09 |
Centerline shown in left side view is
wrong. The long arm of the left side rail needs to be *above* the centerline. |
48.09 |
Rear view. The reamed .250"
hole, .015" oversize, can go to .375" for easier assembly. |
48.13 |
Cocking switch knob, .250" thru
hole does not need to be reamed. |
48.20 |
Recoil pin, the .156" dimension
should be .100" |
48.21 |
Note B , the .093" hole is the
one inside the extractor slot. |
48.30 |
Part number for best fit woodruff key
cutter: Rutland 7299-2025 |
48.30 |
Extractor, detail E, add note:
Install in magazine to drill hole in correct place. |
52.00 |
Add note: The base plate bolts to the
elevating plate, so the 4 holes in the square pattern need to line up. The
holes in the base plate are shown 45 degrees out of true position |
53.00 |
Part C, the ½" -32 thread is not
correct, it should be 5/8" - 32. |
|
Loctite 609 is a very good bonding
agent for installing 5/16" dia. liners in any kind of 22 RF barrel. |
|
|
|
|